DaleH
FOUNDER of Classic Parker Forum
That helps immensely when looking for information, as there may be someone right in the next harbor who could help you out!
Thanks!
Thanks!
Please ADD your LOCATION to your profile ...
- Thread starter DaleH
- Start date
Help Support Classic Parker Boat Forum:
capecodtom
New member
Just joined 9-22-13. Picked up 96 Parker 2110 w/2002 Honda 200 4S, original owner, garaged since new, trailered only, Honda download, 100 hrs in 10 years, always maintained, bottom never painted, like new, original green canvas like new, trial was at 41K with two, no trim tabs but tilt motor and gets up on plane in seconds. Cuddy like new, with seating a bit sparse but mostly just 2 /3 of us fish. Anyone had these 2110 off Nantucket/Vineyard/Monomoy? I own it now and was just informed about this site. Any advice comments on the 2110. Sold a 22 mako CC. I love this boat. Thank you
capecodtom
New member
First out bringing back from Maine where purchased and after 50 gallons of fresh fuel on top of what was in Parker 2110......... no go after 5 minutes at 3500in then ca chug up and down RPM and lose power. Fuel? Thermostats? Fuel Pump? Fuel tank issue in a 96 Parker 2110? Any help/advice much appreciated.
bbrown
Member
Smith Point Marina, Reedville Virginia
bbrown":iejv04sv said:
Not here...
At the top of this page (under the boat graphic) is the link for the "User Control Panel".
"Profile" > "Edit Profile"
Go there and put your location into the "Location" field.
Pontyc
New member
New owner of a 2000 Parker 2520 MVSC relocated from North Carolina to Mandeville Louisina. Great boat! I have some projects to do on it though and would like some experienced advise.
1) Corroded and leaking windows. Yes the black ones. Main focus right now is to stop the leaking side sliders.
2) interior lining is stained (rusting hardware bolts, window leaks) and is degrading into dust! Can it be cleaned and preserved some how?
3) No bow pulpet or anchor roller. Looking to install a windless and SS bow roller. Anyone done this? Equipment used? How did you get around the anchor locker?
1) Corroded and leaking windows. Yes the black ones. Main focus right now is to stop the leaking side sliders.
2) interior lining is stained (rusting hardware bolts, window leaks) and is degrading into dust! Can it be cleaned and preserved some how?
3) No bow pulpet or anchor roller. Looking to install a windless and SS bow roller. Anyone done this? Equipment used? How did you get around the anchor locker?
Truckindog
Member
Mt Dora ,Fla
Truckindog":lzzwo79e said:
Not here...
At the top of this page (under the boat graphic) is the link for the "User Control Panel".
"Profile" > "Edit Profile"
Go there and put your location into the "Location" field.
smacmurp":3cfx4kz8 said:
Not here...
At the top of this page (under the boat graphic) is the link for the "User Control Panel".
"Profile" > "Edit Profile"
Go there and put your location into the "Location" field.
kidfreediver
Well-known member
Lol
woodpile
Member
Pittstown N.J.
kidfreediver
Well-known member
Lol
classic1800
New member
Been gathering info here for a couple of years .
saltwaterspecie
Member
North Shore of Long Island,N.Y.
Luv2fish
Well-known member
Megabyte":28k0k0yg said:
In my lazy boy recliner. [emoji3]
dunlap273
Member
Just registered. Looks like great site. Tons and tons of good and practical info. Proud owner of 2008 Parker 2120 SE. Long Beach Island, NJ
