Search results

Progressive for ins and towing. Boating mag sub just expired...not renewing.

Can it be done? yes Is it practical? no Use a unit that runs on DC

I used total boat performance and thickener. It takes a little fudging with measuring, set times and temps. But after some trial and minor errors I can pretty much mix for any condition. Wish I had found the Wart-method before.

for a moment there I thought I was on a different web site

Your 115 is 377lbs, The capacity rating is set at 150hp (427lbs at the time) for a reason. The 200hp rated 1801 has a custom soleplate, overglassed transom, modified splashwell and relocated deck drains. I wonder if the console is moved forward a bit. You talking adding 152lbs on the transom for...

Warm the hose (i left mine out in the sun) and don't skip out on the lube....you want the lube. Some Mule line and a help to assist with the push-pull.

and the winner is............................................................

Yeah, something is holding you back. You should be at 38-40mph all day long with that motor. Check your lower units drive ratio. You may be running the wrong prop.

For efficiency I was just trying to reduce obvious drag and the extra 1.5" helps keep the skeg out of the water when tilted up. Performance is difficult to express without hard data but the spray pattern is better. I'm still running WOT 40mph @ 6,000 as I was before.

Rust stain removal has been beat to death and it's not rocket science. Try this ,I use that, so an so swears by this. The active ingredient in Bar keepers Friend (as well as other rust stain cleaners) is oxalic acid . Buy it in bulk powder form and mix it with water in a spray bottle or a paste...

I just raised mine this past spring. Parker set it up one from the lowest setting. I was also concerned about going too high. Raised it all the way up and it's perfect.

Are you planning on doing a modified water pickup?

I was looking for the one that goes on top of the console

Plug the hole(s) and drill with a hole saw. When I repaired mine I used a piece of 3/4 plywood and clamped it to the transom to cover the holes.

Where's the rest of the boat? I could use an electronics box.

Here is the newest listing for a 2010 1801 w/200 E Tec and trailer Ends 11/30/2023 10:27:00am https://recoup.bid.assetworks.com/bid/f?p=2501:4001::::4001:p4001_ITEM_ID,P4001_AUCTION_ID,P4001_MAIN_IMAGE_ORDER_ID,AI_STORE:26250,31708,1,NCS

Sold $10,050.00

My bad, I thought I posted the SE drawing. I'll look to see if I have the correct drawing.