Search results

An island called SBI in so cal

Yes. I used starboard thanks

Went to launch my 2022 2320 SL Parker. The Yamaha 300 4.2 engine would NOT go up so I could remove the rubber support and motor lock on the outboard. I had plenty of battery power however engine would not go up. I took my boat directly to West Coast Marine in Costa Mesa Ca. Two expert...

Does anyone know the name of the manufacturer and the color name of the upholstery used in 2022 / 2320 SL Helm seat? Thanks

Thanks!

Red Snaper SBI

Completed installation of GSD 28 Sonar Module. The challenge was finding a secure place to mount. Removed transducer cable from 8610 xsv and installed to GDS. I also installed a BlueNet 30 and port switch. I added a Satellite Compass and commissioned. Compass works great. I also tested sonar...

Hey thanks for the tip. “An ounce of prevention is worth a pound of cure”.

Thanks! I will note and use on next project

Hello. I bought 2 trays from boat outfitters on line then modified them. They come with two cup holders on each tray/ I only needed one so I cut three cup holders off and joined the two trays.

Swapped stainless steel nuts and bolts and replaced with aluminum grade. Purchased at McMaster Carr. Hopefully I’m good now. Warthog 5 thanks for saving me grief down the road. “Good advice is only good if taken”

Hey thanks for pointing this out. I just did a little more research on this and yes you are correct. I just picked up aluminum 10-24 screws with aluminum washers and will replace stainless steel with aluminum this weekend.

I bought 20ft of 2” Taco Metals Boat Rub Rail and 15 ft of Black Rail Insert on EBay. I fastened the rail closest to the transom (every 6 inches) using 10-24 SS bolts with nylon lock nuts. When I got to the corner I used a heat gun to soften the rail in order to make the bend. I had to use both...