Search results

" 5200 rpm which gives me 30-32 mph and a 2.1 mpg fuel burn" 5200 seems high, no??

I saw a picture on here with one, but I'd think the motor would want to keep the stern pointed to current/wind when spotlocked.

your switch and breaker are backwards.

I'm also concerned about the ease of getting the rods out of some of the "double" arrays. There isn't too much clearance between them and I could see the reels hanging up while pulling out rods from the forward holders.

Looks good. I think I'm also a proponent of the airspace. I dread this project, but I'm trying to soak up as much info as possible until the time comes. Does anyone use any of the new composite materials instead of the sealed wood for the deck bracing?

Thanks guys. What I have is either the 3/4 or 7/8" represented by the middle and right one above. I'll measure when I'm back at the boat. thanks you for the source.

Yes. Sorry, I think its the male side. Its a clip. Something like this... https://www.sailrite.com/Loxx-Pull-It-Up-Fastener-Windshield-Clip-7-8-Nickel-Plated-Brass-Stainless?quantity=1&custcol_qty_in_pack=2

Edit to the above...It must be the male portion that attaches to the windshield that I need replaced.

When removing the enclosure, a couple of the female portion of the snaps pulled from the windshield. Yes, I should have taken more time when removing it, but I didn't have any! This half of the snap is still attached to the curtains. Is there a procedure to replace the half attached to the...

I installed 3 12V-100aH Weiz LiPos and I'm very please so far. I installed them with a shunt based battery monitor, and a Yandina trollbidge. The battery monitor only shows the discharge, and does not account for the recharge. Hindsight, I believe this makes sense as the shunt is installed on...

Wondering if anyone has repowered with a 350hp outboard - Suzuki or other. One has become available, however I'm not sure if I should wait for the 300hp.

Nice! What fittings did you use on the bow rail?

Where did you have the cooler racks made? A 165qt cooler is a nice addition vs the noninsulated boxes I have under my seats. Thanks for the info and good luck with the sale!

Nice rig! Who made the seats?

Thanks warthog for the compliments and constructive criticism. I plan to implement some of the additional steps this offseason when I remove the motor for storage.

You won't need the starboard. The height of the shuttle slide is enough to clear the lip. The quick release on the shuttle slide basically allows the whole thing to slide out the back by removing 2 wing nuts. In my install, I don't have enough room behind the shuttle slide before it hits the...

After reading many other informative posts, I’d figure I’d share my install. I can’t yet vouch for the functionality of it yet, but so far it looks good. I opted to mount port side utlizing a shuttle slide mount. Note that I have it mounted on a custom plate I made that hasn’t been tested by...

I'm in the process of wiring up a yandina trollbridge. Haven't tested it out yet. Hopefully I'll be in the water next week.

Ok. Reading now that ALL of the bottom paint has to be removed prior to a barrier coat. I think the stuff coming off seems more hard than ablative, but either way my intention wasnt to remove it all. I feel guilty because some of the gel coat exposed was roughed up pretty good with the sander. I...

I've taken on the fun task of removing what could be 20 years of bottom paint! The bottom wasn't terrible, but paint was thick, peeling in places, chipped in places, and generally rough. This is my first season with the boat so I'm trying do it right. I'm going at it with a chisel and sander...