1998 2300T Big Bay Wiring Diagram

[kjstephe]

I have recently acquired a 1998 2300T Big Bay and have some trouble shooting to do. Nothing major but the wiring diagram would be helpful if any one could share.

The biggest question I have is, the boat is prewired for a trolling motor(no trolling motor was ever installed). Need to know if that wiring goes through the center console or just to the bilge where the batteries are.
The other is baitwell pump not working but that is just trouble shooting I have not done yet.
The wiring diagram would be nice to have though.

 

[pelagic2530]

Good luck. Those wiring diagrams can be tough to come by. Parker's not always the greatest with their reference material.

If you post what problems you're having, and what steps you've already taken, we have some pretty electrically savvy members on here that might be able to help you out.

Welcome aboard!

 

[warthog5]

Hmmmmmm? Prewired TM......I saw this on a Key West.....Boat was bought new.....TM was installed 3yrs later.....The factory wiring had to be thrown away...It laid in the bilge and with the wires open end ruined it.....and 6ga is not big enough to make that length of run IMO. Don't forget...It needs a Circuit Breaker and a Master ON/OFF switch and that switch needs to be used! Power sitting at the TM all the time will cause corrosion....and it's the cause of Mother boards going out IMO.

 

[GZB]

I have recently acquired a 1998 2300T Big Bay and have some trouble shooting to do. Nothing major but the wiring diagram would be helpful if any one could share.

The biggest question I have is, the boat is prewired for a trolling motor(no trolling motor was ever installed). Need to know if that wiring goes through the center console or just to the bilge where the batteries are.
The other is baitwell pump not working but that is just trouble shooting I have not done yet.
The wiring diagram would be nice to have though.

I own the same boat (2000). If you ever acquire a wiring diagram please post it (or link etc). I'm sure there are a few of us on this site that could use it!