willyk9
Well-known member
Most likely will be removing the rear seat on my 2320, any tips on filling the holes?
2320 Remove Rear Seat
- Thread starter willyk9
- Start date
Help Support Classic Parker Boat Forum:
I'm not sure how thick the area is the screws go through, if it's a cored area? You can purchase a quart of factory gel coat from your local Parker dealer but you are only supposed to use gel coat up to a fairly thin amount. The mixture below would be used to build the holes out and then you would top them off, last 1/8th inch or so, with gel coat. I'm by far not the most experienced person on here working with this stuff, but I have filled several holes like this.
Use a syringe to fill the holes with a Polyester resin. Small holes you may not need the Cabosil. See what others say about that too.
Cabosil Filler Quart - Aerosil, Fumed Silica Powder, Thickener, Resins and More
Sold by: Pro Marine Supplies
$14.99
Polyester Laminating Resin-quart-includes 1 Oz Bottle of MEK Hardener
Sold by: Pro Marine Supplies
$24.99
http://youtu.be/jGPAx98pZmM
Use a syringe to fill the holes with a Polyester resin. Small holes you may not need the Cabosil. See what others say about that too.
Cabosil Filler Quart - Aerosil, Fumed Silica Powder, Thickener, Resins and More
Sold by: Pro Marine Supplies
$14.99
Polyester Laminating Resin-quart-includes 1 Oz Bottle of MEK Hardener
Sold by: Pro Marine Supplies
$24.99
http://youtu.be/jGPAx98pZmM
