805mike
Member
- Joined
- Feb 13, 2021
- Messages
- 10
- Reaction score
- 1
Hi 805Mike, my cockpit 'pie-plate' access covers are also made by "Innovative Product Solutions". Best I can tell, they are no longer in business. I would like to find the 'O' rings for them. Do you know of a source for the "O-rings" and/or a source for the exact replacement? They are Innovative Product Solutions; Part #M6AP.... (On a 2013/2014 Parker 2520 XLD)....I took me a while to find out the hatch is made by “innovative product solutions”. The underside was covered in oil and dirt and I could not see the part number. If anybody is looking to replace this hatch it is plug and play. The screw holes of the current iteration match the old one. See below.
View attachment 30217View attachment 30218
On my boat the bilge hatch was larger than any of the cabin hatches. I don’t have a bench seat as previous owner had two capt chairs. Maybe your hatch was from the bench seat?On my 2003 2520 the aft hatch is the same as the two under the cabin bunks, I swapped them around. The one from under the bunk was like brand new.
Hi 805Mike, my cockpit 'pie-plate' access covers are also made by "Innovative Product Solutions". Best I can tell, they are no longer in business. I would like to find the 'O' rings for them. Do you know of a source for the "O-rings" and/or a source for the exact replacement? They are Innovative Product Solutions; Part #M6AP.... (On a 2013/2014 Parker 2520 XLD)....
Thank you! I had not seen this before....i found the 6 inch access plate on the same website I ordered the hatch from.
Boatoutfitters.com
These are anchored by 4 screws here is the link : Innovative Access Plate - White
i also found the same product ,6 inch access plate by innovative product solutions , but anchored by 6 screws.
https://www.greatlakesskipper.com/i...505-203-6-inch-arctic-white-boat-access-plate
Hi Brent, thanks for the 'heads-up' on Great Lakes Skipper.... 805 Mike has also recommended and sent a like above.... I went to their site and they have a section dedicated to Parkers.Check Great Lakes Skipper
they have a lot of Parker parts
I took me a while to find out the hatch is made by “innovative product solutions”. The underside was covered in oil and dirt and I could not see the part number. If anybody is looking to replace this hatch it is plug and play. The screw holes of the current iteration match the old one. See below.
View attachment 30217View attachment 30218THank you for posting!
I am saving info. as I will eventually have to replace mine on my 2008 2320. Same looking back end. I have to power wash all the time the floor and that lid as it all browns easily. Love the pic!