Lenco 12x12 edge mount trim tabs

[shawnee83]

I'm replacing my 12x12 tabs with 12x18's so I'd like to Give away the old 12x12 tabs to someone who could use them. The boat spent 1 season in the water up in MA and after has been stored on a trailer so they are in ok shape. After checking them out more closely, the bottom paint appears to have degraded the hinge area a little. Due to this, I will offer them up to anyone who wants them if they are willing to pay for the shipping cost. If no takers after some time, I'll just scrap them. See pics below. PM me if you have any questions.

 

[shawnee83]

Changed these to FREE if buyer pays to ship them. Added pics.

 

[gw204]

This may be a silly question but is this just the planes or are you including the actuators and wiring too?

 

[shawnee83]

This may be a silly question but is this just the planes or are you including the actuators and wiring too?

Sorry, just the tabs. I just didn't take off the actuators yet. I will be using the on the 12x18's as these actuators are only 1 season old.

 

[shawnee83]

No longer for sale. I scrapped them.

 

[Moochie]

I have a 2007 2520mv, my tabs mount under the boat in a recessed area, is that how yours are? I was wondering how larger tabs would mount . Moochie,thanks

 

[shawnee83]

No, mine were mounted on the bottom edge of thevtransum the traditional way. I'm not sure how you would modify the resesed type.

 

[juniorg]

Where did get the 12 x 18" tabs? I have the factory 12" on my 2320 and I would like to upgrade them too. Are u offsetting the actuator? And I'm assuming they are edge mount style

 

[shawnee83]

Where did get the 12 x 18" tabs? I have the factory 12" on my 2320 and I would like to upgrade them too. Are u offsetting the actuator? And I'm assuming they are edge mount style

I got my 12x18" tabs from BOE Marine. You should be able to Google them. I purchased the tabs only because I had just replaced my actuators the year before when I first bought the boat. If you boat is several years old, you may want to consider just purchasing both as a kit as you get a better deal. You can just hold on to the actuators in case you need them later. I didn't offset the actuators on mine but several folks here have done so and say it works fine. You will just have to make that call. Yes, you still need to purchase the edge mount style. Here is a link to my project on the tabs. Let me know if you have anymore questions. Good luck with yours!
viewtopic.php?f=11&t=15477

 

[juniorg]

Thank you for the info can't wait to swap them out.