Parker 18 Stringer layout pics or diagram???

[malabo]

I have a small soft spot on the floor of my Parker 18 where some screws weren't sealed properly. I am going to cut a small section out and replace it with Coosa. I need to know what is underneath it so that I can cut accordingly relative to the stringers. I have not been able to find a drawing or pictures of an 18 without the floor deck on it.

Can someone post or PM me pics or a drawing of the 18 without the deck?

See pic below of where the soft spot is.


The specific model as per the ID plate is 18' Sport O/B

Thanks, DP

 

[windknotnc]

If you call or email Parker with your hull ID they will send you a pdf of the stinger layout. Based on where your circle is and how big the soft spot is it appears that this area is above the foam box section between the main stringer and the outside stringer. The 21' is a little bit bigger but the layout is probably very close. Check out the sticky 21 Rehab and see the layout in the pics.

 

[malabo]

If you call or email Parker with your hull ID they will send you a pdf of the stinger layout. Based on where your circle is and how big the soft spot is it appears that this area is above the foam box section between the main stringer and the outside stringer. The 21' is a little bit bigger but the layout is probably very close. Check out the sticky 21 Rehab and see the layout in the pics.

Thanks Windknot. I've read through your rehab project, pretty impressive. I hope I don’t have to go to that extent, but maybe soo. Won't know until I start cutting.

I emailed Robin at Parker this morning with a pic of my ID plate, hopefully she can send me the diagram based on that. I don’t have the HIN handy.

I hope the stringer layout is similar to yours on the 21'. That should make it pretty straight forward to repair my small spot.