Rod holder Instalation

miky2884 · Feb 14, 2011

We installed 2 new rod holders in the stern of my 2320 this weekend. Everything went well used the rod holder as a template, drilled a center hole and then used a hole saw to do the rest bolted them up instead of screws . Again amazed at how well built and how thick everything is on these boats! Picture below of the piece that was removed. Sealed the edges of the holes up with 5 min epoxy and good to go.

I am going to post under here to show where I would have liked to have mounted these, but we where unsure if the bait box was going to get in the way curious to see if anyone has mounted them there before, and if so could you please give me some info on how it worked out, as i would still like to mount 2 there.

miky2884 · Feb 14, 2011

miky2884 · Feb 14, 2011

This is where i would have liked to have mounted the 2 holders in the space between each bait well. I was worried the tube of the holder would be to big and i would end up having to cut into the larger bait well in the center. I didn't want to take the chance to cut a hole and then find out that that would have been the case. Again if anyone has mounted a rod holder here before i would appreciate it if you let me know how it went, as I would still like to put two here(there is the same space on the other side of the tank)

windknotnc · Feb 14, 2011

What is all of that white stuff on the ground? Ha Ha...we are looking at 75 degrees on Friday in Eastern NC.

miky2884 · Feb 14, 2011

Yeahhhhhh that would be snow, cabin fever is really starting to kick in, i am working on her snow or not, id take 75 degrees right about now!! We will be around 60 on Friday so not to bad, heading in the right direction!