Which tabs?

Classic Parker Boat Forum

Help Support Classic Parker Boat Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Dawgs

Well-known member
Joined
Oct 24, 2014
Messages
98
Reaction score
0
Which tabs will work best for a 2520 with a modified vee? Electric? Hydraulic? Size?
 
Dawgs":3kip9l12 said:
Which tabs will work best for a 2520 with a modified vee? Electric? Hydraulic? Size?

Many of us have upgraded the factory 12x12 tabs with 24x9 or 30x9.
Some folks are happy with their Lenco electric, but I think you will find that most folks here have opted to install Bennett hydraulic units.
24x9 Bennetts are what my boat wears.

Do you have tabs of any kind on your boat now?
 
Right now I do not have any tabs on my boat
 
Not sure about Lenco, but I do know that Bennett customer service is the best you will find in the industry.
If you discover that you need extra hose, an extra long fitting (for an extra thick transom), or even longer actuators to position the hydraulic fitting higher on the transom, Bennett will swap out your parts for the parts that you need, no charge.

My yard installed my tabs for me and I did not know they were using the same hydraulic pass-thru that were used by the boat levelers, so the hydraulic line was run external.
Had I known, I would have swapped my actuators with Bennett for longer ones to make the hydraulic lines internal, rather than external.
Fortunately, the yard did a good job, and other than appearance, they work just fine.

As you can see, my boat could have easily fit 30" tabs, so what you use is up to you.
These 24's have been a huge improvement over the 12x12's it wore before.
 

Attachments

  • 01 tabs.jpg
    01 tabs.jpg
    501.3 KB
Back
Top