willyk9
Well-known member
Bit the bullet and purchased a 18xhd dome, battle wagon 6" fore leaning 4 degree mount, and a cable clam.
Going to do the install myself, have seen the notes regarding epoxy for the holes and a few other pictures but here is my question.
I plan to mount on the raised portion of the 2320 roof in the middle, most likely as far forward as possible.
- Is that a hollow channel between the interior and exterior roof?
- If I remove the black cover that goes the width of the interior over the wiper motors will I have access to get to the wiring and bring it down to the helm?
Any pictures and tips would be appreciated, thanks!
Going to do the install myself, have seen the notes regarding epoxy for the holes and a few other pictures but here is my question.
I plan to mount on the raised portion of the 2320 roof in the middle, most likely as far forward as possible.
- Is that a hollow channel between the interior and exterior roof?
- If I remove the black cover that goes the width of the interior over the wiper motors will I have access to get to the wiring and bring it down to the helm?
Any pictures and tips would be appreciated, thanks!